Controls; Handlebar; Engine Start/Stop Button - Sea-doo SAR 2018 Series Operator's Manual

CONTROLS

NOTE: Some vehicle safety labels are not shown on illustrations. For information
on vehicle safety labels, refer to
smo2016-001-005_a

1) Handlebar

The handlebar controls the direction of
the watercraft. During forward opera-
tion, turning the handlebar to the right
steers the watercraft to the right and
inversely.
WARNING
Check handlebar and correspond-
ing steering nozzle operation be-
fore starting. Never turn handle-
bar while someone is near the rear
of the watercraft. Keep away from
the propulsion system.
2) Engine START/STOP
Button
The engine START/STOP button is lo-
cated on the LH handlebar.
______________
40
WATERCRAFT SAFETY LABELS
smo2011-003-018_a
TYPICAL
1. START/STOP button
Engine Starting and Stopping
Refer to
subsection for detailed instructions.
Waking Up the Electrical System
Press the START/STOP button once
without installing the tether cord on
the engine cut-off switch.
This will power up the electrical sys-
tem; the information center will cycle
through a self-test function and will
then go blank after a few seconds.
The electrical system will stay pow-
ered up for approximately 3 minutes
after the START/STOP button was de-
pressed.
subsection.
OPERATING INSTRUCTIONS