Setting The Water Hardness; Language - Jura S8 Instructions For Use Manual

4 Permanent settings in programming mode
Setting the water
hardness

Language

30
T Touch 'Back' the number of times needed to display the start
screen again.
The harder the water is, the more frequently the S8/S80 needs to be
descaled. It is therefore important to set the water hardness accu-
rately.
The water hardness was set when the machine was first used. You
can change this setting at any time.
The water hardness can be adjusted on a continuous scale between
1° dH and 30° dH.
Precondition: The start screen is displayed.
T Touch ' P '.
'Machine settings'
T Touch 'Machine
'Switch off after'
T Move your finger across the display until
displayed in the centre.
T Touch 'Water
'Water hardness'
T Now move your finger to the left or right to change the set-
ting.
T Touch 'Save'.
'Saved' appears briefly on the display.
'Water hardness'
T Touch 'Back' the number of times needed to display the start
screen again.
In this programme item you can set the language used by your S8/
S80.
Example: Proceed as follows to change the language from
to 'Deutsch'.
Precondition: The start screen is displayed.
T Touch ' P '.
'Machine settings'
T Touch 'Machine
'Switch off after'
settings'.
hardness'.
settings'.
'Water hardness' is
'English'