Inserting The Chain - Markusson Grindomatic V12 Original Instruction Manual

Grindomatic
4. Press the grinding head positioning button to
move the grinding head in both directions and
make sure that the top-plate angles are the
same.
5. If the top-plate angles are not the same (for
example 26° in the right direction and 30° in
the left direction), adjust the nuts (A) a 1/2-turn
at the time.
6. Repeat steps 2-5 until the top-plate angles are
the same in both directions.
5.2.4

Inserting the chain

1. Check the chain for double-links (2 left cutters
or 2 right cutters) or joint-links, and make sure
that the chain is not damaged.Mark double-
links or joint-links to make it easier to see them
when the chain is sharpened.
2. Attach the stop clamp on a tie-strap between a
double-link or a joint-link.
A
3. Place the chain, with the cutter to the left of the
depth gauge, into the groove on the chain vise.
4. Attach the chain weight to the chain
5. Pull the chain around by hand to make sure
that it runs freely in the chain vise.
CAUTION Always wear safety gloves,
protective glasses, and any other personal
protective equipment suitable for the current
work task.
Grindomatic 201708 EN 19
Operation