Markusson Grindomatic V12 Original Instruction Manual page 40

Assembling the stand
9. The stand will need to be secured on the floor
through the holes located at the base of the
stand.
10. After the stand is assembled and secured, bolt
the AC/DC converter to the back of the stand
by aligning the two holes located at the top and
the bottom of the converter to the holes on the
stand.
11. Next, place the machine on the stand. Fix it to
the stand through the 3 holes located at the
back and front of the machine with the bolts
and nuts provided.
F
J
40 Grindomatic 201708 EN
K
K
K
I
L
J
12. To connect the AC/DC converter unit to the
machine, plug in the black and red power cable
into the control panel through the slot on the left
hand side of the machine.
Note: For best performance, use the converter
provided by Markusson.
WARNING Put the power converter where
there is as little dust as possible and out of
reach of sparks from the machine.
13. To connect the air unit, slip the air line that has
been attached to the pneumatic chain tensioner
into the slot marked as "out" at the back of the
machine. Then insert the second airline into the
slot marked "in". Next, connect the line with the
fitting unit to an air compressor with a minimum
of 5 and maximum of 8 bar.
WARNING Attach air hoses and cables
with cable clamps, to make sure no one trips
over them.
Grindomatic
OUT
IN