Operating The Machine - Markusson Grindomatic V12 Original Instruction Manual

Grindomatic
20. Set the chain pusher switch to OFF when the
grinding head is in its uppermost position and
the chain lock is not engaged.
IMPORTANT If the chain has double-links, pull
the chain back so that the grinding starts on
the second double-link. If the chain has a joint
with an irregular cutter sequence, start grinding
behind it, to the left of the stop clamp.

5.3 Operating the machine

WARNING Always wear safety gloves,
protective glasses, and any other personal
protective equipment suitable for the current work
task.
WARNING Stop the machine immediately if it
does not work correctly!
Note: For a video demonstration of how to install
and operate the machine, go to markusson.se.
Note: Discard the chain when the longest part of the
cutting tooth is shorter than 4mm (5/32"), or if you
find cracks or burrs in the chain.
4mm
1. Set the grinding wheel switch to ON to start
grinding motor.
2. Set the chain pusher switch to ON to start the
feeding of the chain and the movement of the
grinding head. The sharpening will start after
this.
3. Wait until the machine has sharpened all the
links until the stopper. When the stopping
clamp is reached, the chain feeding and the
grinding stops.
4. Lift the grinding head to its most upright
position.
5. Set the grinding wheel switch to OFF.
6. Set the chain pusher switch to OFF.
Grindomatic 201708 EN 23
Operation