Markusson Grindomatic V12 Original Instruction Manual page 39

Grindomatic
2. Then insert the rod through the unit and insert
the bottom part of the rod onto the base of the
stand.
3. To secure the rod, start from the top. Place the
provided nut on the top of the hole and insert
the bolt from the bottom of the rod towards the
top, and then through the nut.
J
E
Assembling the stand
4. Do not completely tighten the bolt. Once the
bolt is in place, slide it into the slot located at
the top part of the stand, then tighten the bolt.
5. Once the top portion is secured, use the
second set of nuts and bolts to fix the bottom
part of the rod to the stand. After securing both
the bottom and the top, bring the stand back to
an upright position.
6. There are two air lines to be attached to the
pneumatic chain tensioner: one with an air
fitting unit attached to the end and one without
a fitting.
7. Insert the line without the fitting through the
hole located on the left side of the stand,
bringing it from back to the front. Route the line
through the back of the rod and insert it into the
pneumatic tensioner until it sits in place.
8. Now attach the chain holders that will allow you
to keep loops of chain up off of the ground.
Insert the provided long bolts into the holes
located on both sides of the stand and fix them
in place with a 13 mm wrench.
H H
D
Grindomatic 201708 EN 39