Markusson Grindomatic V12 Original Instruction Manual page 15

Grindomatic
3. Once the grinding wheel has been verified,
you're ready to begin the install.
4. Start by removing the grinding wheel shield (C)
to access the wheel attachment nut (B). Use
the provided Allen wrench to loosen the
retaining screw (D).
A
5. Remove the wheel attachment nut from the
hub.
6. Next, insert the appropriate wheel onto the hub
and, using moderate pressure with your hands,
secure the wheel attachment nut to hold the
wheel in place.
cause it to break.
7. Finally, reposition the shield and secure it in
place with the retaining screw.
D
the wheel guards in place.
8. Before using the grinder, you'll need to check to
ensure the wheel is properly installed.
9. With the power off, gently spin the grinding
C
wheel and check for wheel wobble.
10. Conduct a final check for proper assembly by
turning on the main power and switching on the
wheel power switch while standing to the side.
Look for vibrations due to wheel oscillation or
B
other interference.
safe distance from a grinder while in operation.
Note: To get the best performance from your
grinder, ensure the grinding wheel is centered
over the vise. Refer to this user manual or the
provided video for specific instructions.
Installation
WARNING Over-tightening the wheel can
WARNING Never start the grinder without
WARNING Always keep bystanders at a
Grindomatic 201708 EN 15