Assembly Instructions For Bbq With; Condiments Drawer & Other Features - Masport BG6286BS-WS-RB Owner's Manual

16 (b)
Screw SS M6*12 (b)
33
4th & 5th
13. 1) Remove all packaging from the side burner prior to fitting the Right Hand (side Burner) table to the BBQ. Prepare the BBQ prior
to fitting the side table, refer to previous instructions. Then assemble the Side burner assembly (item 17) as described in step 13. If the
knob (item 15) has not been fitted then assemble the knob (item 15) to the valve shaft on side burner assembly (item 17), and make sure the
red point on the knob is on the upper direction.
2) Connect the side burner hose to the main manifold, and tighten carefully.
14. Put the Drip tray (item 18), Grease cup (item 19) into the grill body and 2pcs Step screw (item e) - (the step screws will be on the
assembly already) to the rear of the grill body to secure the drip tray.
NOTE:
Some barbecue models require the stepped screws (item e) are removed to insert the drip tray. Once the tray is positioned
correctly, refit step screw (item e).
14
15
Note!
Before operating this appliance for the first
time LEAK TEST ALL JOINTS.

ASSEMBLY INSTRUCTIONS FOR BBQ WITH

CONDIMENTS DRAWER & OTHER FEATURES
Open the carton by removing the
shipping straps then slitting along both
ends. Cut the tape only by a small
amount in the middle, finish by lifting the
carton flaps with your hand.
Unpack the entire carton, this carton will
be used as a surface protector as the
cabinet is being built. Open the carton
as shown and place where the BBQ will
be assembled
NOTE:
Letters in the bracket after every screw, helps you identify the item number from the parts list on page 6, from the fastener kit.
Tools needed for assembly: Crosshead screwdriver, 10mm A/F Spanner
Open the fastener kit, place to one side, 4 pcs screw (SS) M6x12 (item b) & 4pcs fibre washer (item c) for Hood Assembly.
Before commencing assembly, open the cartons and lay all of the components on the floor. Familarise them against the parts list on page 21, as some
of these instructions refer to this parts list.
NOTE:
When assembling the barbecue, ensure it is sitting on a flat surface.
1. 1) Remove the screws , nuts and the washers fastened to the Weight Plate.
2) Fix the weight Plate (item 32) under the base tray (item 1) with these 2pcs Screw M6*40 (item g) 2pcs washer, (item h) 2pcs Nut M6 (item f).
Screw M6*40
1
18
19
Step screw (e)
Product Description
Carton Identification
Product Part Number
Washer
32
Nut M6
15