Table of Contents
Advertisement
SYSTEM DELIVERY
5
After placing your order, a 3D Systems representative will contact you to schedule your shipment delivery date . Ensure that the
area into which you intend to place your SLA system is ready, and that you have appropriate forklifts or other lifting devices
before scheduling the installation of your system by a 3D Systems representative . The following information will guide you
through this preparation phase .
PREPARATION FOR RECEIVING
Being that the ProX 800 crate is quite large, have an adequate forklift available before you begin to unload the crate from the
shipping truck . Make sure that the available forklift, or other lifting device, can handle the load during unloading and during
uncrating . Refer to the illustration,
forklift .
NOTE: Crates can only be unpacked by, or under the supervision of, a 3D Systems Customer Support Engineer .
3D Systems accepts no responsibility for missing items if crates are opened without an authorized Customer
Support Engineer present supervising this procedure .
Inform your receiving personnel that these crates will be arriving and arrange for a location to store them in until your
appointment with a 3D Systems Customer Support Engineer .
Inform your receiving personnel that the crates allow forklift access from the side to make sure they can be properly unloaded
or moved to your warehouse until the 3D Systems representative is scheduled to install the systems .
If you do not have an adequate forklift on-site, contact the shipping company in advance of the shipment to discuss whether
one is needed for receiving the shipment .
NOTE: The forklift must have a minimum of 1 .8m (6 ft) forks for safe and stable transport, but we recommend
2m (6 .5 ft) .
It must be rated for the weight of any of the components you ordered . The lift loops are designed to accept 1 .5 in (38 mm) thick,
4 in (approximately 100 mm) wide forks. Fork extensions will not fit in the lift loops on the machine frame. Review the charts
below for crated dimensions and weights of the components .
SHIPMENT ARRIVAL
The ProX 800 system will arrive in a variety of crates and/or pallets - the largest crate being the ProX 800 .
Once your shipment arrives, first inspect the crates for any physical damage. Then, after inspection, receive the crates.
The following chart lists both crated and uncrated dimensions and weights for every possible crate that you may have ordered .
Verify your order and compare to the listed items below . Crates or pallet dimensions and weights may vary .
Width
Description
cm
ProX 800
191
Laser Unit
94
(laser, power supply)
Manual Offload Cart
127
3D Systems, Inc.
"Forklift lift points - ProX 800 Printer" on page 12
Crated Specifications
Depth
Height
(in)
cm
(in)
cm
(in)
(75)
165
(65)
249
(98)
(37)
(25)
(35)
64
89
(50)
174
157 .5
(68 .5)
(62)
Weight and Dimensions - System Components
(continued on next
for locations and dimensions for the
Weight
Width
Depth
kg
(lb)
cm
(in)
cm
(in)
1724
137
(54)
160
(3800)
(200)
(7 .5)
(20 .9)
91
19
53
160
(350)
76
140
(29 .8)
(55 .1)
pg .
11)
10
Uncrated Specifications
Height
Weight
cm
(in)
kg
(lb)
(63)
226
(89)
1497
(3300)
(6 .7)
(50)
17
22 .7
118
90
(200)
(46 .3)
Weight range
w/ resin
kg
(lb)
n/a
n/a
n/a
Advertisement
Table of Contents
