Appendix C Configuration Or Firmware Upgrade With A Usb Drive - Raritan PX3TS User Manual

Appendix C Configuration or Firmware Upgrade
with a USB Drive
You can accomplish part or all of the following tasks simultaneously by
plugging a USB flash drive which contains one or several special
configuration files into the PX3TS.

Configuration changes

Firmware upgrade

Downloading diagnostic data
Tip: You can also accomplish the same tasks via the TFTP server in a
DHCP network. See Bulk Configuration or Firmware Upgrade via
DHCP/TFTP (on page 550).
To use a USB drive to configure the PX3TS or upgrade
firmware:
1. Verify that both the USB drive and your PX3TS meet the
requirements. See
2. Prepare required configuration files. See
page 540).
3. Copy required configuration files to the root directory of the USB
drive.
 For firmware upgrade, an appropriate firmware binary file is also
required.
4. Plug the USB drive into the USB-A port of the PX3TS.
5. The initial message shown on the front panel display depends on the
first task performed by the PX3TS.
 If no firmware upgrade task will be performed, a happy smiley as
shown below is displayed after around 30 seconds.
=-]
 If the USB drive contains the firmware upgrade data, the PX3TS
first performs the firmware upgrade, showing the upgrade
message on the front panel display, and then shows the happy
smiley when the firmware upgrade completes successfully. See
Firmware Upgrade via USB
6. After the happy smiley appears, press and hold one of the control
buttons next to the front panel display for one second until the
display turns blank.
7. Wait for several seconds until the PX3TS resumes normal operation,
indicated by the normal message of the front panel display.
System and USB Requirements
Configuration Files
(on page 549).
(on page 540).
(on
539