Security Configuration Commands - Raritan PX3TS User Manual

config:# security ipAccessControl ipv4 enabled <option>
config:# security ipAccessControl ipv4 defaultPolicyIn <policy>
config:# security ipAccessControl ipv4 defaultPolicyOut <policy>
config:# security ipAccessControl ipv6 enabled <option>

Security Configuration Commands

A security configuration command begins with security.
Firewall Control
You can manage firewall control features through the CLI. The firewall
control lets you set up rules that permit or disallow access to the PX3TS
device from a specific or a range of IP addresses.

An IPv4 firewall configuration command begins with security
ipAccessControl ipv4.

An IPv6 firewall configuration command begins with security
ipAccessControl ipv6.
Modifying Firewall Control Parameters
There are different commands for modifying firewall control parameters.

IPv4 commands
Enable or disable the IPv4 firewall control feature:
Determine the default IPv4 firewall control policy for inbound
traffic:
Determine the default IPv4 firewall control policy for outbound
traffic:

IPv6 commands
Enable or disable the IPv6 firewall control feature:
Determine the default IPv6 firewall control policy for inbound
traffic:
Chapter 7: Using the Command Line Interface
441