Chapter 6 Using Snmp; Enabling Snmp; In This Chapter Enabling Snmp - Raritan PX3TS User Manual

Transfer switch

Hide thumbs Also See for PX3TS:

Table of Contents

This SNMP section helps you set up the PX3TS for use with an SNMP

manager. The PX3TS can be configured to send traps or informs to an

SNMP manager, as well as receive GET and SET commands in order to

retrieve status and configure some basic settings.

Enabling SNMP .....................................................................................350

Configuring SNMP Notifications ............................................................352

SNMP Gets and Sets ............................................................................357

By default, SNMP v1/v2c is enabled on the PX3TS so the PX3TS can

communicate with an SNMP manager. If you have disabled the SNMP, it

must be enabled to communicate with an SNMP manager.

Note that read-only access is enabled and the community string is public.

To enable SNMP:

1. Choose Device Settings > Network Services > SNMP. The SNMP

Settings dialog appears.