To define a simple edge trigger
Press
1
Do one of the following:
2
•
or
•
Press one of the
3
occur on the rising edge, falling edge, or either edge of the input
signal.
Example
Connect the probe for channel 0 to the front-panel calibration test point.
Then set up a falling edge trigger on channel 0. You should see a stable
display of the channel, as shown below.
Figure 9
Edge Trigger on Channel 0
.
Edge
Press the
softkey under
Trg In
input as the trigger source.
Select a channel as the trigger source using either the Select knob, the
Entry knob, or the softkey.
You can choose a channel that is turned off as the source for the edge
trigger.
softkeys to choose whether the trigger will
Edge
To define a simple edge trigger
to choose the External Trigger
Source
Getting Started
47