Testing, Adjusting, and Troubleshooting the Analyzer
To make the test connectors
To make the test connectors
The test connectors connect the logic analyzer to the test equipment.
Table 8
Materials Required
Description
BNC (f) Connector
Berg Strip, 8-by-2
Berg Strip, 1-by-2
100 Ω 1% resistor
Jumper wire
Build the first test connector using a BNC connector and an 8-by-2
1
section of Berg strip.
Solder a jumper wire to all pins on one side of the Berg strip.
a
Solder a jumper wire to all pins on the other side of the Berg strip.
b
Solder the center of the BNC connector to the center pin of one row
c c
on the Berg strip.
Solder the ground tab of the BNC connector to the center pin of the
d
other row on the Berg strip.
Figure 52
8-by-2 Connector Setup
156
Recommended Part
HP 1250-1032
HP 0698-7212
Qty
2
1
1
2