4. Synchronisation
4.6. Function Diagrams for Position Synchronisation
4.6.1. SyncStart to a Stationary Master
If the slave is synchronised to a stationary master drive, the slave will remain stationary. However,
if a fixed offset is defined for the activated gear ratio, the slave travels to the extent of this offset
during synchronisation.
4
Illustration 4.7: synchronising to a stationary master
4.6.2. SyncStart to a Running Master
If synchronisation is effected to a running master, the slave drive first makes up the deviation of
distance then it proceeds synchronously with the master. Any Offset setting is taken into account.
60
®
MG.33.Q1.02 - VLT
is a registered Danfoss trademark
Syncronising Controller MCO 350 Operating
Instructions