Danfoss MCO 350 Operating Instructions Manual page 59

Syncronising Controller MCO 350 Operating
Instructions
Illustration 4.6: Control behaviour with position synchronisation
It appears from the diagram that the control accuracy depends on the master acceleration and
on the speed deviation between slave and master. A typical application for this type of synchro-
nising could be the replacement of a mechanical shaft. Or mixing controls where a mixing rate is
required.
The following example shows how embossing patterns on moulds is controlled. This application
requires accurate position control.
®
MG.33.Q1.02 - VLT is a registered Danfoss trademark
4. Synchronisation
4
59