Eaton Powerware 9135 Two-in-One UPS 5000/6000 VA User Manual page 31

2. Recommended. Remove the UPS battery tray (see Figure 5):
S
Remove the UPS front cover (six screws).
NOTE A ribbon cable connects the control panel to the UPS. Do not pull on the cable or
disconnect it.
S
Place the front panel above the UPS.
S
Remove the two battery retaining brackets (four screws).
S
Slightly pull the battery tray, then lift it to extract it.
EATON Powerware
® 9135 Two−in−One UPS (5000/6000 VA) User's Guide
Figure 5. Removing the Battery Tray
www.powerware.com
INSTALLATION
S
164201726 Rev 1
25