Figure 32. Port Setup Screen - Powerware 5075 kVA Installation & Operation Manual

Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup
screens. The Port Setup screens allow you to specify settings for the two serial
communication ports on the UPS. Figure 32 shows the Setup Serial Port 1 screen.
UPS System Normal
Alarm: None
Notice: None
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Meters Events
The small return arrow ( ) appears in the upper right corner of the Port Setup
screen. This arrow is a reminder that you can press the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons
to change the port configuration. To change a setting, press the
to move the highlight to the setting you want to change. To scroll through the
available options for that setting, press the
settings upon exit from this screen, be sure the SAVE field is set to YES.
The setup screens for Port 1 and Port 2 are identical.
62
Uninterruptible Power System
MODE
TERMINAL
Statistics Graphics

Figure 32. Port Setup Screen

Powerware BPIII Harsh Environment UPS 50--75 kV Installation and Operation
04 MAY 1998
Setup Serial Port 1
RATE DATA/STOP HANDSHAKING
9600 8 1 XON / XOFF
Setup
or pushbutton. To save the
14:25:58
SAVE
NO
pushbutton on the
and pushbuttons
164291261 Rev. F 111503