Configuring the Serial Ports
You must configure the port for communications using the LCD screen and
pushbuttons on the UPS Monitor Panel.
Select Port 1 or Port 2 (optional) from the Setup menu to display one of the Setup
Port screens. The screens for Port 1 and Port 2 are identical, and allow you to
specify settings for the two serial communication ports. Figure 43 shows the Setup
Serial Port 1 screen.
UPS System Normal
Alarm:
None
Notice: None
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Meters
A small return arrow ( ) appears in the upper right corner of the Setup Port screen.
This arrow is a reminder that you can press the
Panel to toggle the pushbuttons between the menu box and the information area.
If the scroll bar is in the menu box, press the
information area. The first setting (Mode) is highlighted. Press the
pushbutton to move the highlight to the setting you want to change. To scroll
through the available options for that setting, press the
To save the settings upon exit from this screen, be sure the Save field is set to YES.
Powerware BPIII Harsh Environment UPS 50--75 kVA Installation and Operatio
164201261 Rev. F 111503
Uninterruptible Power System
Mode
TERMINAL
Events
Statistics Graphics
Figure 43. Setup Serial Port 1 Screen
03 JAN 1994 14:23:45
Setup Serial Port 1
Rate
Data/Stop
Handshaking
9600
8
1
XON / XOFF
Setup
pushbutton on the Monitor
pushbutton to toggle to the
or
Save
NO
or
pushbutton.
n
89