The optional Relay Interface Module (RIM) uses relay contact closures to
indicate the operating status and alarm condition of the UPS system. The
module uses an RS422 serial interface line and may support up to eight critical
loads. A maximum of two monitoring accessories (RMPs, RIMs, or SCMs) can be
installed. Refer to Chapter 4, Table C for the number of accessories permitted.
Figure 10 shows the RIM with its four 15-pin connectors labeled J1 through J4.
Drawing 164201261---8 in Appendix A outlines the enclosure dimensions.
15-PIN D-SUB
CONNECTORS
Powerware BPIII Harsh Environment UPS 50--75 kVA Installation and Operatio
164201261 Rev. F 111503
Installing a Relay Interface Module
Relay Interface Module
J1
J2
J3
Figure 10. Relay Interface Module
FLUSH MOUNT
SURFACE
MOUNT
FOR HANGING
J4
CONTINUES
AT UPS
n
29