2. Disconnect the drive 2 SATA-power Y-cable:
a. If the drive 2 SATA connector is still connected, press and hold the release button, and then disconnect
it from the system board.
b. Remove the drive 2 power cable clip screw, and then remove the clip.
c. Disconnect the drive 2 power connector.
4
Remove the middle frame
Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
•
T-15 Torx screwdriver
•
Flathead screwdriver
Procedure
1. Remove the RJ-45 port bracket.
3
4
5
2
1
3
5
2
1
Remove the middle frame
29