Speed-Duplex - Digisol DG-FS4528P Management Manual

C
OMMAND
This command allows you to disable a port due to abnormal behavior
(e.g., excessive collisions), and then re-enable it after the problem has
been resolved. You may also want to disable a port for security reasons.
E
XAMPLE
The following example disables port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#shutdown
Console(config-if)#

speed-duplex

This command configures the speed and duplex mode of a given interface
when auto-negotiation is disabled. Use the no form to restore the default.
S
YNTAX
speed-duplex {100full | 100half | 10full | 10half}
no speed-duplex
D
EFAULT
Auto-negotiation is enabled by default.
When auto-negotiation is disabled, the default speed-duplex setting is:
C
OMMAND
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
The 1000BASE-T standard does not support forced mode. Auto-
negotiation should always be used to establish a connection over any
1000BASE-T port or trunk. If not used, the success of the link process
cannot be guaranteed when connecting to other types of switches.
However, this switch does provide a means of safely forcing a link to
operate at 1000 Mbps, full-duplex using the
To force operation to the speed and duplex mode specified in a speed-
duplex command, use the
negotiation on the selected interface.
When using the
optimal settings will be determined by the
U
SAGE
100full - Forces 100 Mbps full-duplex operation
100half - Forces 100 Mbps half-duplex operation
10full - Forces 10 Mbps full-duplex operation
10half - Forces 10 Mbps half-duplex operation
S
ETTING
Fast Ethernet ports – 100full for 100BASE-TX ports
Gigabit Ethernet ports – 100full for 1000BASE-T ports
M
ODE
U
SAGE
negotiation
– 679 –
C 28
HAPTER
giga-phy-mode
no negotiation command to disable auto-
command to enable auto-negotiation, the
capabilities
| Interface Commands
command.
command. To set