Adding Static Members To Vlans; Figure 158: Creating Static Vlans - Digisol DG-FS4528P Management Manual

Mustang 4000 managed switch series, layer 2 fast ethernet managed poe switch
Table of Contents

Advertisement

A
S
DDING
TATIC
M
VLAN
EMBERS TO
S
Remove – Removes a VLAN group from the current list. If any port is
assigned to this group as untagged, it will be reassigned to VLAN group
1 as untagged.
W
I
EB
NTERFACE
To create static VLANs:
1.
Click VLAN, 802.1Q VLAN, Static List.
2.
Enter the VLAN ID and VLAN name, mark the Enable checkbox to
activate the VLAN.
3.
Click Add.

Figure 158: Creating Static VLANs

Use the VLAN > 802.1Q VLAN > Static Table page to configure port
members for the selected VLAN index. Assign ports as tagged if they are
connected to 802.1Q VLAN compliant devices, or untagged they are not
connected to any VLAN-aware devices. Or configure a port as forbidden to
prevent the switch from automatically adding it to a VLAN via the GVRP
protocol.
CLI R
EFERENCES
"Configuring VLAN Interfaces" on page 799
"Displaying VLAN Information" on page 806
P
ARAMETERS
These parameters are displayed:
VLAN ID – ID of configured VLAN (1-4094).
VLAN Name – Name of the VLAN (1 to 100 characters).
Status – Enables or disables the specified VLAN.
Port – Port Identifier. (Range: 1-28)
Trunk – Trunk Identifier. (Range: 1-8)
– 325 –
C
13
| VLAN Configuration
HAPTER
IEEE 802.1Q VLANs

Advertisement

Table of Contents
loading

Table of Contents