Speed-Duplex - Digisol DG-GS4528SE Management Manual

| Interface Commands
C 29
HAPTER
Interface Configuration
description
D S
EFAULT ETTING
100BASE-FX: 100full (SFP
1000BASE-T: 10half, 10full, 100half, 100full, 1000full
1000BASE-SX/LX/ZX (SFP
10GBASE-SR/LR/ER (SFP+): 10Gfull
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
10GBASE-SFP+ connections are fixed at 10G, full duplex. When auto-
u
negotiation is enabled, the only attributes which can be advertised
include flow control and symmetric pause frames.
The 1000BASE-T standard does not support forced mode. Auto-
u
negotiation should always be used to establish a connection over any
1000BASE-T port or trunk.
When auto-negotiation is enabled with the
u
switch will negotiate the best settings for a link based on the
capabilities command. When auto-negotiation is disabled, you must
manually specify the link attributes with the
flowcontrol commands.
E
XAMPLE
The following example configures Ethernet port 5 capabilities to include
100half and 100full.
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#
R C
ELATED OMMANDS
negotiation (967)

speed-duplex (968)

flowcontrol (965)
This command adds a description to an interface. Use the no form to
remove the description.
S
YNTAX
description string
no description
string - Comment or a description to help you remember what is
attached to this interface. (Range: 1-64 characters)
27. DG-GS4528FSE
– 964 –
/ SFP+)
27
/ SFP+): 1000full
27
negotiation
speed-duplex
command, the
and