Figure 6-3 Example: Sequence In The Singlestep_Cp Operating Mode - Siemens Simatic S7-1500 Function Manual

Example
The figure schematically shows the sequence in the
In addition to the
since the last synchronization point of the same process image partition ID or of any process
image partition ID has been reached (
TimeSinceAnySyncPoint_ns
The
Figure 6-3
Changing the settings in the watch table
Note
Selecting triggers for monitoring of tags in the SingleStep operating modes
In TIA Portal the watch table in basic mode shows the values for outputs and bit memories
before the processing.
In order to display the tag values after the processing, select the extended mode for the
watch table and then select "Permanently, at end of scan cycle" in the "Monitor with trigger"
column.
See also
Cycle control (Page 223)
S7-PLCSIM Advanced
Function Manual, 12/2017, A5E37039512-AB
OnSyncPointReached
).
function cancels the freeze state.
RunToNextSyncPoint()
Example: Sequence in the SingleStep_CP operating mode
6.3 Synchronize simulation partner
SingleStep_CP
event the virtual controller also sends the virtual time
TimeSinceSameSyncPoint_ns
Virtual time response
operating mode.
/
79