Changing Drill/Drum - Shop fox W1668 Owner's Manual

Changing.Drill/Drum
NEVER. troubleshoot. or.
adjust.the.machine.while.
it. is. running.. Wait. until.
the.machine.is.turned.off,.
unplugged.and.all.working.
parts.have.come.to.a.stop.
before.proceeding!
To.change.drill.bits.and.sanding.drums,.do.
these.steps:
1. DISCONNECT THE MACHINE FROM POWER!
2.. Use the chuck key to open the chuck wide
enough to accept the new bit or the sand-
ing drum mandrel (see Figure.44).
3.. Install the bit or mandrel so the chuck jaws
will grab as much of the bit or mandrel
shank as it can.
• If you are installing a small drill bit, make
sure it is held between three jaws instead
of only two, and NEVER allow a chuck to
grab the fluted body of drill bits.
• If you are installing the sanding drum,
install the paper and drum before install-
ing the spindle into the drill chuck (con-
tact your local SHOP FOX
drums and paper).
4.. Tighten the chuck with the chuck key,
using any of the three key end locations.
(see Figure.45).
5.. Choose the insert that has an opening
which is approximately
sanding drum chosen. For drilling, always
use the table insert (see Figure.46) with
the smallest opening. A table insert is not
needed when a 2" drum is used.
6.. Install the chosen table insert into the
pocket in the top of the table.
7.. Remove the chuck key and reconnect the
power source.
8.. Reverse these steps to remove the drill bit
or sanding drum.
dealer for
®
⁄ " bigger than the
1
4
-34-
Model W1668/W1848 (Mfd. Since 08/16)
Figure.44..Installing bit.
Figure.45..Chuck key engaged.
Figure.46..Sanding drum table insert.