Shop fox W1668 Owner's Manual page 22

DO.NOT over tighten the set screws and strip
the threads or bend the column.
23. With an assistant, position the pocket
over the column (Figure.16).and allow
the headstock to slide down until the col-
umn fully seats up and into the headstock
(approximately 3 ⁄
1
2
Tip: Place a few drops of multi-purpose
grease on the column to help the head-
stock seat more easily.
24.. Align the headstock directly over the foot
of the base as viewed from the front of the
drill press and center it using a plumb bob
and ruler (see Figure.17).
25.. Tighten the two set screws to secure the
headstock to the column (see Figure.18).
26.. Install the belt cover knob with the includ-
ed Phillips head screw (see Figure.16).
").
Model W1668/W1848 (Mfd. Since 08/16)
Figure.16..Aligning the pocket in the headstock
with the column.
Figure.17..Aligning headstock with base.
Figure.18..Securing the headstock to the
-20-
Belt.Cover.
Knob
Set.Screws
column.