Operations; General - Shop fox W1668 Owner's Manual

General

This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
The overview below provides the novice machine operator
with a basic understanding of how the machine is used
during operation, so the machine controls/components
discussed later in this manual are easier to understand.
Due to its generic nature, this overview is NOT intended
to be an instructional guide.
To.complete.typical.operation,.operator.does.following:.
1. Examines workpiece to make sure it is suitable for
drilling.
2. Puts on required safety glasses and face shield.
3. Firmly secures workpiece to table using a vise or
T-slot clamps.
4. Installs correct cutting tool for operation.
5. Adjusts table to correct height, then locks it in
place.
6. Selects appropriate spindle speed according to V-belt
configuration chart located inside belt cover.
7. Connects machine to power, and starts spindle rota-
tion in proper direction for cutting tool installed.
8. Begins drilling.
9. When finished, stops spindle rotation and discon-
nects machine from power.

OPERATIONS

-26-
Model W1668/W1848 (Mfd. Since 08/16)
To. reduce. your. risk. of. serious. injury.
or. damage. to. the. machine,. read. this.
entire.manual.BEFORE.using.machine.
To. reduce. the. risk. of. eye. injury. and.
long-term. respiratory. damage,. always.
wear. safety. glasses. and. a. respirator.
while.operating.this.machine.
If you are an inexperienced operator,
we strongly recommend that you read
books or trade articles, or seek training
from an experienced operator of this
type of machinery before performing
unfamiliar operations. Above.all,.safety.
must.come.first!