Configuring The Illustra Camera Using A Static Ip Address - Illustra Pro 12MP Fisheye Quick Start Manual

4 Open Microsoft Internet Explorer and enter the URL of the camera as shown in the DHCP Server log.
Note:
At factory default, after enabling DHCP manually or if it is the first time the camera has been configured; the
camera will reboot using the Failover IP of the last known static IP address until a DHCP address request is
authorised by the DHCP server. The DHCP requests will remain active unless cameras are changed to Static IP.

Configuring the Illustra Camera using a Static IP Address

The following information states how to install the camera on your network when no DHCP Server is available. In
this situation the camera will be assigned a Static IP Address.
Connect the camera to the computer or network which will be used for the configuration and power on.
Note:
• We recommend that once you are logged into the Web Configuration pages you change the Static IP
Address of the camera so that conflicts can be avoided when using the same Static IP Address to setup
additional cameras.
• In a situation where IP address conflicts arise, Illustra Connect can be used to discover the device.
- End -
14