Cable Sealing - Illustra Pro 12MP Fisheye Quick Start Manual

Mounting the camera
Step Action
1 Place the paper mounting template on the desired installation surface.
2 Drill holes in the correct positions based on the paper mounting template, and insert the plastic
anchors into the holes.
3 Connect the required cables to the device.
4 Place the camera body on the mounting surface to match its alignment holes with the corresponding
plastic anchors.
5 Tighten the plastic anchors with the screws through the camera's alignment holes.

Cable Sealing

Where a conduit is not being used, sealing the cables that are fed through the cable seal is required. This is to
protect the camera and maintain camera performance.
Cable sealing
Step Action
6
- End -
1 Turn the camera so that you can see the cable
seal on the camera underside. You will see that
the cable seal contains three tubes (one open,
two closed).
2 Insert the cable through the open tube in the
cable seal. If you require further cabling, do not
cut off the tubes. Instead, snip the tops off the
closed tubes using a scissors and feed the
cables through the now open tubes, ensuring
that there is not excess space around the
cables.
3 It is required to use the self-fusing tape.Cut the
tape off in lengths to wrap around each cable and
remove the backing from each side
4 Apply the self-fusing tape where each cable
enters the tubes making sure it overlaps itself,
the tube, and the cable.
Illustra Pro 12MP Fisheye Quick Start Guide