Macros Settings; Macros Autostart; Macros Mode - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction

Macros settings

Macros Mode

Macros allow you to write snippets of JavaScript code that can automate parts of your video
endpoint, thus creating custom behavior. Use of macros is disabled by default, but the first
time you open the Macro Editor you will be asked whether to enable use of macros on the
codec. Use this setting when you want to manually enable, or to permanently disable the
use of macros on the codec. You can disable the use of macros within the Macro Editor.
But this will not permanently disable macros from running, because every time the codec is
reset the macros will be re-enabled automatically.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Permanently disable the use of macros on this video system.
On: Enable the use of macros on this video system.

Macros AutoStart

All the macros run in a single process on the video endpoint, called the macro runtime. It
should be running by default, but you can choose to stop and start it manually. If you restart
the video system, the runtime will automatically start again if auto start is enabled.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: The macro runtime will not start automatically after a restart of the video system.
On: The macro runtime will start automatically after a restart of the video system.
D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration Peripherals Maintenance
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
95
Administrator Guide
System settings System settings Appendices