Cameras Camera [1] Gamma Level; Cameras Camera [1] Gamma Mode; Cameras Camera [1] Irsensor; Cameras Camera [1] Mirror - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction

Cameras Camera [1] Gamma Mode

This setting enables gamma corrections, and applies only to cameras which support
gamma mode. Gamma describes the nonlinear relationship between image pixels and
monitor brightness.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Manual
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref.
Cameras Camera [n] Gamma Level.

Cameras Camera [1] Gamma Level

By setting the Gamma Level you can select which gamma correction table to use. This
setting may be useful in difficult lighting conditions, where changes to the brightness setting
does not provide satisfactory results. Requires the Cameras Camera [n] Gamma Mode to be
set to Manual.
Requires user role: ADMIN, INTEGRATOR
Default value: 0
Value space: Integer (0..7)
Define the gamma level.

Cameras Camera [1] IrSensor

A Precision camera has an IR sensor that is used when you operate the codec with a
remote control. The IR sensor is located at the camera front, and the LED flickers when the
IR sensor is activated by the remote control.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: Disable the IR sensor of the camera.
On: Enable the IR sensor of the camera.
D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration Peripherals Maintenance

Cameras Camera [1] Mirror

With Mirror mode (horizontal flip) you can mirror the image on screen. Mirroring applies
both to the self-view and the video that is transmitted to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Off/On
Auto: If the camera detects that it is mounted upside down, the image is automatically
mirrored. If the camera cannot auto-detect whether it is mounted upside down or not,
the image is not changed.
Off: Display the image as other people see you.
On: Display the image as you see yourself in a mirror.

Cameras Camera [1] MotorMoveDetection

This setting applies only when using a Cisco TelePresence PrecisionHD 1080p12x camera.
If adjusting the camera position by hand you can configure whether the camera should keep
its new position or return to the preset or position it had before.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: When the camera position is adjusted manually the camera will keep this position
until adjusted again. WARNING: If moving the camera by hand, the camera will not
register the new pan and tilt values since there is no position feedback. This will result in
wrong pan and tilt values when recalling the camera presets subsequently.
On: When the camera position is adjusted manually, or the camera detects that the
motors have moved, it will first re-initialize (i.e. go to default position) then return to the
preset/position it had before the camera was adjusted.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
83
Administrator Guide
System settings System settings Appendices