Customize The Video System's Touch 10 User Interface - Cisco TelePresence SX20 Quick Set Administrator's Manual

Cisco TelePresence SX20 Quick Set

Introduction

Customize the video system's Touch 10 user interface

You can customize the user interface to allow control of
peripherals in a meeting room, for example lights and blinds, or to
modify the video system's behavior by triggering macros.
This allows for the powerful combination of a control system's
functionality and the video system's user-friendly user interface
(Touch 10).
Example in-room control panel
Consult the CE Customization guide for full details about how to
design custom user interface panels (in-room control panels)
using the In-Room Control editor, and how to use the video
system's API to program the in-room controls. Go to:
► https://www.cisco.com/go/in-room-control-docs
D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration Peripherals
In-room control architecture
You need a Cisco video system with a Touch 10 controller, and a
control system. The control system may be a third-party system,
such as Crestron or AMX, with hardware drivers for peripherals.
It is the control system, not the video system, that controls the
peripherals.
When you program the control system you must use the video
system's API (events and commands) in order to connect with the
controls on the video system's user interface.
Touch 10
Video system
In-room
control
editor
The video system's macro framework may also serve as a
control system. In this case the control system can use the video
system's API to trigger all sorts of local functionality: Speed dial,
language selection, customized system reset, and much more.
Maintenance
(page 1 of 2)
Blinds
API
Climate
Control system
Lights
Other...
In-room control schematics
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
159
Administrator Guide
System settings Appendices Appendices