Error Messages - Fujitsu FI-718PR Operator's Manual

5. Error Messages

This chapter explains the Imprinter error messages.
Error messages are displayed on the operator panel of the scanner. Refer to the error indication that is displayed for
troubleshooting.
HINT
For details on the error indications that are displayed on the operator panel and other errors, refer to the Operator's Guide provided with the
scanner.
Error codes and messages are displayed on the LCD.
Error Code
U5:4A (*1) Imprinter Cover Open
U6:B4 Print cartridge not installed
A0:B2 Imprinter error (RAM)
A1:B3 Imprinter error (communication timeout)
A2:B5 Imprinter error (print head)
A3:B6 Imprinter error (EEPROM)
A4:B8 Imprinter error (ROM)
H6:B1 Imprinter system error
*1: When you open the imprinter print section while the scanner is in standby, only an error message will appear without an
error code. Also, note that buttons on the operator panel are disabled while the imprinter print section is open.
Error Message Action
Close the print section of the imprinter, and load the
document again.
No print cartridge is installed.
Check if the print cartridge is installed correctly.
If the problem persists, write down the displayed
error code and contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service
provider.
An error occurred in the imprinter.
Try the following:
1. Confirm that the EXT cable of the imprinter is
connected properly to the EXT connector on the
back of the scanner.
2. Confirm that the print cartridge is installed
correctly.
3. Turn the scanner off then back on.
If the problem persists, write down the displayed
error code and contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service
provider.
An error occurred in the imprinter.
Turn the scanner off then back on.
If the problem persists, write down the displayed
error code and contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service
provider.
fi-718PR Imprinter Operator's Guide | 15