Loading The Print Cartridge - Fujitsu FI-718PR Operator's Manual

5. Turn the locks inwards.
6. Connect the EXT cable to the connector on the
back of the scanner.
ATTENTION
The imprinter does not work if the EXT cable is not
connected. Scanning without the EXT cable connected will
cause paper jams inside the imprinter.
7. Attach the stacker (removed in step 2) on the front
of the imprinter.
8. Connect the power cable to the scanner.
① Insert one arm.
② Gently slide in the other arm.

2.2. Loading the Print Cartridge

Load the print cartridge in the following procedure.
ATTENTION
When installing the print cartridge, install it properly.
1. Turn off the scanner.
2. Place your hand in the middle part of the print
cartridge and open it as shown below.
Paper guides
3. Remove the packing tape from the print cartridge
holder and the paper guides.
4. Lift the print cartridge holder by pinching the lever
with your fingers as shown below.
5. Take out a new print cartridge.
fi-718PR Imprinter Operator's Guide | 5
Print cartridge holder