Socket 7Ci Quick Start Manual

Use your Bluetooth Scanner 7Ci

3. Scanning Barcodes

After connecting the scanner to your
device, open an application. Put the
cursor where you want to enter data.
Hold the scanner about 4 inches from
the barcode and press and hold the
trigger button. Keep your hand steady
and make sure the red beam covers the
entire width of the barcode.
By default, the scanner will beep and
vibrate, and the LED will flash green to confirm that data was decoded
and sent to the host device.

4. Simultaneous Scanning and Soft Keyboard Support

The Scanner supports simultaneous use of the barcode scanner and
the Apple iOS on-screen keyboard while entering data into an
application.
To open or close the onscreen keyboard, quickly double-press the
power button (like double-clicking a mouse).
After you double-press the power button, the CHS will beep to
indicate that the onscreen keyboard was enabled / disabled.
Watch a video: http://www.youtube.com/watch?v=VhtttoC6ROs

1. Powering ON:

Press and hold down the small
power button until the LED
turns
blue
scanner
twice

2. Powering OFF:

Press
down
power button until
the
twice.
page 1 of 3
Choose 2 Rent
Phone 1 (800) 622-6484
Fax 1 (866) 937-8254
info@choose2rent.com
www.choose2rent.com
and the
beeps
and hold
the small
scanner beeps