Install Forward-Facing Using Lap Belt Only - CYBEX Sirona M Owner's Manual

INSTALL FORWARD-FACING USING LAP BELT ONLY

Note: The Lock-Off is for lap/shoulder belt systems only and is not needed for lap
belt only installation.
1. Remove Tether from Tether Compartment. Route vehicle lap belt through the
red Forward-Facing Belt Path on the side of the Child Restraint. Lift the Seat
Cover on the back of the seat and pull the vehicle belt through the opening on
the side of the Child Restraint.
2. Pass the vehicle belt along the back of the Child Restraint as shown.
3. Pull vehicle belt down through the red Forward-Facing Belt Path on the opposite
side of the Child Restraint. Buckle the vehicle belt. Replace the back of the Seat
Cover after tightening.
1
49
2
3
CLICK!
INSTALL FORWARD-FACING USING LAP BELT ONLY
4. While pushing down on the Child Restraint
lap belt to tighten.
b
5. Locate Tether anchor in your vehicle. Attach Tether Hook. Pull Tether Adjuster
Strap to tighten.
CHECK YOUR WORK
• HOLD Child Restraint at each side near Forward-Facing Belt Paths. Pull side to
side and forward. Child Restraint should not move more than 1 in. (2.5 cm) from
vehicle seat back or side-to-side.
• Make sure ball is between lines on label for forward-facing use (p. 41-42).
If necessary, loosen the vehicle belt and Tether, readjust recline and repeat
installation steps to make sure Child Restraint is installed properly.
• Check installation before every use.
4
a
b
Place belt here.
, pull the loose end of the vehicle
a
5
CLICK!
50