Replacing The Print Roller And The Rewind Assist Roller - CAB SQUIX Service Manual

2 Replacing Assembly Units
2.3

Replacing the Print Roller and the Rewind Assist Roller

1
1
Fig. 3 Replacing the print roller and the rewind assist roller
1. Open the printhead locking.
2. Lift the pinch roller (2) from the rewind assist roller.
3. Remove labels and transfer ribbon from the printer.
4. Turn the roller bearings (5) with the 2.5 mm Allen key out of the side plate (3).
5. Pull print roller (6) and rewind assist roller (4) from the shafts (1) though the side plate (3).
6. Clean the shafts (1)
7. Insert the new rollers (4,6) and slide them onto the concerning shaft(1). Turn the rollers slightly until the hexagonal
shafts engage the hexagonal sockets of the rollers.
8. Put the roller bearings (5) onto the axles of the rollers and screw them into the side plate (3).
2 3
9
6
5
5
4