Oce VarioPrint 6180 User Manual page 238

Load light-weight media into the paper module
• Do not use media that is not wrapped, or not wrapped well.
• Unpack one ream and load the media before you load another ream.
• Load media as soon as possible after unpacking.
Do not use media that was stored outside the printer for more than 2 hours.
• Make sure that the correct media is assigned to the correct paper tray.
Procedure
Action
1 Open the paper tray via the schedule, the trays
view or the button on the control panel of the
paper module. Only one tray can be open at
the same time.
2 Remove the current stack from the tray.
Only remove the current stack when you load
different media in the tray.
3 Take a new stack of media for loading.
Load the media with the grain direction in the
transport direction.
Carefully put the stack in the middle of the pa-
per tray, aligned against the left-hand guide
plate.
Check the stack after loading. Remove sheets
that are shifted or curled during loading.
238 Chapter 11 - Media handling
Turn the knob counterclockwise to move
the side sliders away from the loaded
stack.
Squeeze the green handle of the front
slider to move the trailer-edge sliders
away from the stack.
Remove the stack.
4
Océ VarioPrint 6000 line