Change The Print Delivery Settings - Oce VarioPrint 6180 User Manual

Change the print delivery settings

Introduction
Usually the print delivery settings have been defined in the printer driver.
Overview of the print delivery settings
Setting
[Output location]
[Sort]
[Offset stacking]
[Advanced settings]
[Advanced settings]
Setting
[Sheet order]
Océ VarioPrint 6000 line
Description
Change the output location for the job. The list shows all the out-
put locations that are available for your system.
Make sure there is a match between the selected output location
and the job requirements. For example, when a job requires sta-
ples, you must select an output location that allows stapling.
Change the sorting method of the prints. You can select sort [By
page] or [By set].
[33] Sort by page
[34] Sort by set
Stack the prints with an offset.
This setting is only available when the [Offset stacking] setting of
the active [Workflow profile] is set to [Sets (as in job)].
Finishing equipment often requires that the printed sheets are de-
livered in a certain order. For finishers that are integrated in your
printing system, the required settings are adapted automatically.
However, sometimes it can be necessary to change a number of
settings manually, for example when you want to finish the prints
using offline finishers. If required, you can change the [Sheet or-
der], [Sheet orientation], [Print order] and [Rotation].
Description
[Face up]
Deliver the prints face up, first sheet on top.
[Face up reverse]
Deliver the prints face up, last sheet on top.
[Face down]
Deliver the prints face down, first sheet on top.
[Face down reverse]
Deliver the prints face down, last sheet on top.
Change the print delivery settings
Chapter 9 - Carry out print jobs
4
149