Pre-Installation And Application Warnings - Directed DS4+ Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
No takeover feature is available on Push-to-Start vehicles. The vehicle will shut down as soon as a door is opened.
Š
To remote start the engine, the hood, hatch, and all doors MUST be closed.
Š
Keyless and Smart Key will remain functional during remote start.
Š
All connectors are displayed from the wire side (unless specified otherwise).
Š
It is important to check that the fuses are positioned correctly in the module. Proper fuse positioning is displayed on each
Š
wiring diagram.
Refer to the "Vehicle connections" following the installation diagram.
Š
General notes: This section highlights important information for this specific firmware.
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin.
[1]
The siren is ONLY required when enabling the security features during module flashing.
[2]
Autolights Interrupt ONLY required if vehicles are equipped with Autolights.
[3]
Connection required ONLY if Pit Stop/Idle mode is desired.
[4]
5
Keys required for 1 Keys required for
programming operation
933.TL1 5.03.185 2010 Toyota Camry (Smart Key)
© 2017-10-17 Directed. All rights reserved.
0