Initialization Of The Gyro; Adjust Servolimit For Channels - GRAUPNER Falcon 12 Manual

Initialization of the gyro

Adjust servolimit for channels

SERVOLIMIT
> 1: -150% +150% SEL
2: -150% +150% SEL
3: -150% +150% SEL
4: -150% +150% SEL
5: -150% +150% SEL
6: -150% +150% SEL
7: -150% +150% SEL
SERVOLIMIT
> 1: -150% +83% +83% STO STO
2: -150% +150% SEL
3: -150% +150% SEL
4: -150% +150% SEL
5: -150% +150% SEL
6: -150% +150% SEL
7: -150% +150% SEL
S1035_Falcon_12_jh_V1
4. First select a low value (see value section for starting points) and
carry out a test-flight. If gyro stabilization is not sufficiently pro-
nounced, increase the value step by step until the level of cor-
rection is as required; if the model already oscillates, reduce the
value step by step.
5. Move on to "elevator" or "rudder" and select the desired value
(or OFF).
6. Leave the settings for "Factor" to OFF.
7. Activate the gyro for one axis only at first, and then to establish
the optimum setting for that axis, rather than for several axes
simultaneously.
Once the model has been switched on, the gyro immediately
becomes active but still needs to be initialized. To initialize the gyro,
keep your model still when you switch it on. After approx. 2 seconds
in still position, the ailerons move briefly in both directions. These
"wiggles" indicates that initialization has been successful and that
calibration is complete. Only now the model can be moved again.
Al the sticks must be left in the central position!
Note
During the initialization the neutral position will be detected, for
this reason it is very important that the model is not moved during
the activation!
In the same way during the gyro initialization also the central posi-
tion of each control channel is saved. By gyro suppression the gyro
correction is reduced with increasing control deflection, at +/- 100%
of the gyro is deactivated.
In this menu, you can limit the servo travel for all channels. Limit the
<
servo travel to the maximum possible deflection, so that the servos
can not run in the stop in the gyro operation. Move the cursor to the
desired line (by further downward move of the cursor will be dis-
played further channels), here "1" for channel 1 Pressing the SET
button is pressed the "SEL" field in "STO".
Now move the stick of channel 1 in the desired direction and posi-
< tion, while the corresponding percentage display is shown inverted.
Now press the SET button again and the set value is displayed and
stored. Go through the procedure for the other channels.
19 / 36