Switch Setting; Operation Display - FUTABA Mega Tech 3PK Instruction Manual

Throttle speed/TH-SPEED (Throttle system)
Sudden trigger operation on a slippery road only
causes the wheels to spin and the vehicle cannot ac-
celerate smoothly. Setting the throttle speed func-
tion reduces wasteful battery consumption while at
the same time permitting smooth, enjoyable opera-
tion.
Operation
Throttle servo (amp) operation is delayed so that the drive wheels will not spin even
if the trigger is operated more than necessary. This delay function is not performed
when the trigger is returned and at brake operation.
- Low side throttle speed (See [Operation range setup].)
Use when adjusting the speed from the neutral position to the set point.
- High side throttle speed (See [Operation range setup].)
Use when adjusting the high side speed from the set point.
Remark: Regarding the throttle speed set value; the actual delay value varies
depending on the system (HRS, PCM, PPM). The delay when the HRS system is used is approximately 1/
3 that of the PCM and PPM systems.

Switch setting

Use PS1, PS2, or PS3 to switch the throttle speed function ON/OFF.
See the function select switch function (page ).

Operation display

* The LED blinks while the throttle speed function is on.
Calling the setup screen
* Calling from menu screen
(Initial screen)
Use the
button to select the
MENU
menu screen.
Press the
MENU SELECT
Use the
button to select the
function.
Press the
* When the direct call button is set,
the setup screen is also called by the
following method:
(Initial screen)
Press the
DIRECT SEL
Press the button set
at this function.
44
or
button.
or
button.
button.
TH-SPEED/Smooth, quick starts possible
No TH-SPEED/Tires slip and vehicle does not move
Use the or button to
select the setup item.
* blinks at the current
setup item.
Setup items
RA NGE : Operation range
SPEED : Speed amount
MODE : Function ON/OFF
* The LED blinks while the throttle
speed function is on.
* The black part of the bar graph is the
operation range.
* Throttle trigger position
* "L40" indicates operation below
40%.
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).