FUTABA Mega Tech 3PK Instruction Manual page 31

- Steering dual rate (DL1) check
At initial set-up, steering dual rate is assigned to grip
dial DL1 (upper) at the grip of the transmitter. Operate
the DL1 dial and check if the D/R value displayed on
the screen changes. After checking D/R, set the steer-
ing dual rate to 100%.
- Throttle ATL (DL2) check
At initial setting, throttle ATL is assigned to grip dial
DL2 (lower) at the grip of the transmitter. Operate the
DL2 dial and check if the ATL value displayed on the
screen changes. After checking ATL, set throttle ATL
to 100%.
(Set-Up Procedure When Installed In a Car)
When installing the servos in a car, performing function set-up in the following order
is recommended.
1. Perform step 3. Trims Initial Set-Up of Preparations on the
preceding page.
2. Set the servo direction of operation using the Reverse
function. (Page )
The servo installation method and linkage direction depends
on the kit. Therefore, the servo operation direction may have
to be reversed relative to transmitter operation. Before in-
stalling the servo, check the operating direction and set it us-
ing the Reverse function.
3. Set the subtrim and adjust the servo neutral point. (Page )
4. Set the trigger travel by adjusting the throttle trigger me-
chanical ATL to you liking. (Page )
5. Set EPA of each channel and adjust the servo throw
(travel). (Pages )
31