FUTABA Mega Tech 3PK Instruction Manual page 36

Throttle steering angle (EPA) adjustment
(Preparation)
- Before setting the throttle steering angle, set the throttle
ATL dial (initial setup: DL2) to the maximum steering
angle position 100%.
- Select setup item "TH-FWD" and make the following
adjustments:
1 Throttle (forward side) adjustment
Pull the throttle trigger fully to the high side and use
the (+) and (-) buttons to adjust the steering angle.
However, when using an FET amp, set to 100%.
2 Throttle (brake side/reverse side) adjustment
Push the throttle trigger fully to the brake side
and use the (+) and (-) buttons to adjust the
steering angle. However, when using an FET
amp, set to 100%.
3 When adjusting the steering angle of another
channel immediately after this, see the adjust-
ment method for that channel. When ending ad-
justment, return to the initial screen by pressing
the (END) button three times.
3rd channel servo steering angle (EPA) adjustment
(Preparation)
- Select setup item "3C-UP" and make the following ad-
justments:
1 3rd channel servo (up side) adjustment
Set the 3rd channel dial fully to the up side (+
side) and use the (+) and (-) buttons to adjust the
steering angle.
2 3rd channel servo (down side) adjustment
Press the (DN) button and select setup item "3C-
DWN" and set the 3rd channel dial fully to the
down side (-) and use the (+) and (-) buttons to
adjust the steering angle.
3 When adjusting the steering angle of another
channel immediately after this, see the adjust-
ment method for that channel. When ending ad-
justment, return to the initial screen by pressing
the (END) button 3 times.
36
100%
Setup item switching
- Use the (DN) and (UP) buttons to
switch the setup item.
- Others switch the setup item (direc-
tion) linked with the throttle trigger.
Setup item switching
- Use the (DN) or (UP) button to switch
the setup item.