Programming Options - DSC TL280LE Installation Manual

Internet and lte/hspa dual-path alarm communicator;lte/hspa alarm communicator;cellular alarm communicator;internet and hspa dual-path alarm communicator; internet alarm communicator

Hide thumbs Also See for TL280LE:

Installation manual (65 pages)

Installation manual (57 pages)

Instruction manual (72 pages)

Table Of Contents

Table of Contents

OFF: Ethernet receiver 2 is disabled.

[3] Reserved

[4] Cellular receiver 1 is enabled. Default (ON) OFF for TL2803G(R)E.

ON: Cellular receiver 1 is enabled.

OFF: Cellular receiver 1 is disabled.

[5] Cellular receiver 2 is enabled. Default (ON) OFF for TL2803G(R)E.

ON: Cellular receiver 2 is enabled.

OFF: Cellular receiver 2 is disabled.

[6] Reserved

[7] DLS Over Cellular. Default (ON).

ON: DLS is enabled on the cellular path.

OFF: DLS is disabled on the cellular path.

NOTE: Program this toggle as OFF to prevent DLS from using the cellular path.

NOTE: If this toggle is OFF, DLS sessions will occur on the Ethernet path only, regardless of the primary

path set in section [005] toggle option [4]. If it is ON, the communicator will connect to the primary

path first for DLS and if the session fails, the secondary path will be used.

[8] Network Trouble Suppression. Default (OFF).

ON: GSM/Ethernet/Supervisory troubles and restore signals follow delay timer as programmed in

section [226].

OFF: GSM/Ethernet/Supervisory troubles and restore signals are sent immediately.

[007] DNS Server IP 1

Default (000.000.000.000)

Enter the IP address for DNS server 1. Format is 4 fields, each field is a 3 digit decimal. Valid range: 000-

255.

NOTE: If no value is programmed and DHCP is used, the DHCP server will configure the address. If an

address is programmed and DHCP is used, the programmed address will be used instead of the

DHCP address.

[008] DNS Server IP 2

Default (000.000.000.000)

Enter the IP address for DNS server 2. Format is 4 fields, each field is a 3 digit decimal. Valid range: 000-

255.

NOTE: If no value is programmed and DHCP is used, the DHCP server will assign this value. If an

address is programmed and DHCP is used, the programmed address will be used instead of the

DHCP address.

[009] Language

Default (01)

OPT Language OPT Language OPT Language OPT Language

English

02 Spanish

03 Portuguese

04 French

05 Italian

06 Dutch

07 Polish

08 Czech

NOTE: Programming this section with an invalid language will default to English (01).

NOTE: After programming this section, perform a 'Default Language in section [999][11] to have pro-

grammable labels available in the selected language.