Lever Blade Installation - SRAM code rsc 2018 Service Manual

L e v e r B l a d e I n s t a l l a t i o n
1 Insert the lever blade bushings into both sides of the lever.
Steps to reassemble the R lever blade assembly:
Place the washer on the cam/push rod assembly. Apply a small amount
of SRAM® DOT grease to hold the washer in place.
Install the lever return spring onto the cam/push rod assembly.
While holding the cam/push rod/lever return spring/washer in place,
install the assembly onto the lever blade and proceed to step 2.

Lever Blade Installation

37