L e v e r B l a d e I n s t a l l a t i o n
1
Insert the lever blade into the lever body with the inboard spring
pressing against the lever body.
Align the pivot holes of the lever blade and the lever body.
Make sure the lever return spring is seated properly in the lever. The
outboard end of the spring must press against the lever blade, while
the inboard end of the spring must press against the lever body. If the
return spring is not seated properly the reach adjustment feature of
the lever blade will be inoperable.
2
Apply a small amount of Loctite® Threadlocker Blue 242® onto the
threads of each pivot bolt.
®
3
Use a T10 TORX
wrench to thread each pivot bolt into the bearings
on each side of the lever body.
Inboard spring
Loctite Threadlocker Blue 242
T10 TORX wrench
Lever Blade Installation
26