Lever Blade Installation - SRAM RSC Service Manual

L e v e r B l a d e I n s t a l l a t i o n
1 Install the lever blade.
Line up the pivot holes of the lever blade with the pivot holes in the
lever body.
Make sure your lever return spring is seated properly in the lever. The
outboard end of the spring must press against the lever blade, while
the inboard end of the springs must press against the lever body. If the
return spring is not seated properly, you will not be able to adjust the
reach of the lever blade.
2
Apply a small amount of Loctite® Threadlocker Blue 242® onto each
pivot bolt.
3 Use a T10 TORX® wrench to thread each pivot bolt into the bearings on
each side of the lever body.
space between frames
space between steps
Loctite® Threadlocker Blue 242®
T10 TORX wrench

Lever Blade Installation

26