Lever Blade Installation - SRAM GUIDE RSC 2015 Service Manual

L e v e r B l a d e I n s t a l l a t i o n
1 Use your hand to install the lever blade.
Line up the pivot holes of the lever blade with the pivot holes in
the lever body.
Make sure your lever return spring is seated properly in the lever.
The outboard end of the spring must press against the lever blade,
while the inboard end of the springs must press against the lever
body. If the return spring is not seated properly, you will not be
able to adjust the reach of the lever blade.
Apply a small amount of 242® Blue Loctite® onto each pivot bolt.
2
3 Use a T10 TORX® wrench to thread each pivot bolt into the
bearings on each side of the lever body.
242 Blue Loctite
T10 TORX wrench

Lever Blade Installation

17